 |
|||
|
Page Title:
Armor Plate, Steel, Wrought, High-Hardness |
|
||
| ||||||||||
|
|  INCH-POUND
MIL-A-46100D (MR)
w/INT. AMENDMENT 2
13 July 2007
USED IN LIEU OF
MIL-A-46100D (MR)
w/AMENDMENT 1
29 June 1990
MILITARY SPECIFICATION
ARMOR PLATE, STEEL, WROUGHT, HIGH-HARDNESS
This specification is approved for use by all Departments and Agencies of the Department
of Defense.
1. SCOPE
1.1 Scope. This specification covers quenched and tempered high-hardness wrought steel
armor plate for lightweight armor applications for recommended thickness up to 2 inches
inclusive (see 6.1 and 6.3).
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3, 4, or 5 of this
specification. This section does not include documents cited in other sections of this
specification or recommended for additional information or as examples. While every effort
has been made to ensure the completeness of this list, document users are cautioned that
they must meet all specified requirements of documents cited in sections 3, 4, or 5 of this
specification, whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards,
and handbooks form a part of this document to the extent specified herein. Unless
otherwise specified, the issues of these documents are those cited in the solicitation or
contract.
Comments, suggestions, or questions on this document should be addressed to: Director, U.S.
Army Research Laboratory, Weapons and Materials Research Directorate, Materials Applications
Branch, Attn: AMSRD-ARL-WM-MC, Aberdeen Proving Ground, MD 21005-5069 or emailed to
rsquilla@arl.army.mil. Since contact information can change, you may want to verify the currency
of this address information using the ASSIST Online database at 6Hhttp://assist.daps.dla.mil/.
AMSC N/A
FSC 9515
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals