 |
|||
|
|
|||
| ||||||||||
|
|  MIL-A-48449A(AR)
Should any one item of a special
4.4.3 Failure of sample.
sampling fail to meet the specified test requirements,
acceptance of the represented inspection lot will be suspended
by the Government until necessary corrections have been made by
the contractor and the resubmitted samples have been approved
(See 4.3.3).
Except as otherwise provided
4.5 Inspection equipment.
for by the contract, the contractor shall supply and maintain
equipment in accordance with the applicable requirements of
MIL-I-45607.
Where
4.5.1 Government furnished inspection equipment.
the contract provides for Government furnished test equipment,
care and maintenance of test equipment shall be in accordance
with the applicable requirements specified in MIL-I-45607.
4.5.2
Contractor
furnished
inspection
equipment.
Unless otherwise specified in
4.5.2.1 Government design.
the contract, all inspection equipment specified by drawing
number in specifications or SQAP forming a part of the contract
shall be supplied by the contractor in accordance with
technical data listed in the Technical Data Package (TDP).
The contractor shall design and
4.5.2.2 Contractor design.
supply inspection equipment comparable with the "Test Methods
Procedures" specified in 4.6 of this specification and with
and
the component inspection procedures specified in "Examination"
Since toler-
Facilities" requirements of MIL-F-13926.
and "Test
ance of test equipment is normally considered to be within 10%
of the product tolerance for which it is intended, this inherent
error in the test equipment design must be considered as part
Thus, concept, con-
of the prescribed product tolerance limit.
struction, materials, dimensions and tolerances used in the
design of the test equipment shall be so selected and controlled
as to insure that the test equipment will reliably indicate
acceptability of a product which does not exceed 90% of the
prescribed tolerance limit, and permit positive rejection when
Construction shall be such as to facilitate
non-conforming.
routine calibration of test equipment.
In conjunction with 4.5.2.2, the
4.5.2.3 Test equipment.
following Standard Test Equipment shall be utilized in the
performance of the applicable tests specified in 4.6.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals