2 November 1979
29 December 1950
ADAPTER, BOMB RACK, 30-INCH, AERO 1A
This specification is approved for use by all Departments and
Agencies of the Department of Defense.
Scope. This specification establishes the requirements
for the manufacture and inspection of a bomb rack adapter. The adapter
gives a 355.6 millimeter (14 inch) suspension bomb rack a 762 millimeter
(30 inch) suspension capability allowing the bomb rack to carry and
release stores weighing from 45 to 1,814 kilograms (100 to 4,000 pounds).
The test limits in this specification define minimum acceptable capabil-
Issues of documents. The following documents of the
issue in effect on date of invitation for bids or request for proposal,
form a part of this specification to the extent specified herein.
-Testing, Store Suspension and Release
Equipment; General Specification for
-Hooks, Bomb Rack, General Specification
Beneficial comments (recommendations, additions, deletions) and any
pertinent data which may be of use in improving this document
should be addressed to: Engineering Specifications and Standards
Department (Code 93) Naval Air Engineering Center, Lakehurst, N.J,
08733 by using the self-addressed Standardization Document Improve-
ment Proposal (DD Form 1426) appearing at the end of this document
or by letter.