reserves the right to perform any of the inspections set forth in the
specification, where such inspections are deemed necessary to assure
that the supplies and services conform to prescribed requirements.
The inspection of the
Classification of inspection.
adapters shall be classified as follows:
First article inspection (see 4.3)
Quality conformance inspection (see 4.4)
First article inspection. First article inspection shall
consist of all of the inspections listed in Table I. First article in-
spection report format shall be in accordance with MIL-STD-831 (see
Sampling for first article inspection.
adapter samples shall consist of the first three adapters manufactured
on contract. The adapters shall be permanently labeled A, B and C for
ease of identification. Failure of the adapters to pass any of the
first article inspections shall be cause for rejection (see 6.3).
Quality conformance inspection.
inspection shall consist of the following inspections:
Individual Inspections (see 4.4.1)
Sampling Inspections (see 4.4.2)
Quality conformance inspection report format shall be in accordance with
MIL-STD-831 (see 6.3).
Individual inspections. Individual inspections are those
inspections conducted on each adapter. Individual inspections for the
adapters are shown in Table II, Group 1. Failure to pass any of these
inspections shall be cause for rejection of the adapter.
Sampling inspections. A random sampling of the adapters
shall be selected by the procuring activity from each production lot in
accordance with Table III and shall be subjected to the inspections
listed in Table II, Group 1 and Group 2. Group 1 inspections shall be
conducted prior to Group 2 inspections. Failure to pass any of these
inspections shall be cause for rejection of the entire lot (see 6.3).
Inspection conditions. Unless otherwise specified, all
inspections shall be performed under the following conditions:
Room temperature. Room ambient of 25±10°C (77±18°F)