 |
|||
|
|
|||
| ||||||||||
|
|  MIL-A-81371(AS)
3.6
Design Data - No data is required by this specification (other than
reports accompanying samples submitted for testing) or by applicable documents, unless
specified in the contract or order (see 6. 7).
4.
QUALITY ASSURANCE PROVISIONS
.
4.1
Responsibility for Inspection - Unless otherwise specified in the contract
or purchase order, the supplier is responsible for the performance of all inspection require-
ments as specified herein. Except as otherwise specified, the supplier may utilize his own
facilities or any commercial laboratory acceptable to the Government. The Government
-
reserves the right to perform any of the inspections set forth in the specification where
such inspections are deemed necessary to assure that supplies and services conform to .
.
prescribed requirements.
4.1.1
Classification of Tests - Items covered by this specification shall be
subjected to the following tests to determine compliance with all applicable requirements:
(1)
Preproduction Tests
(2)
Initial Production Tests
Acceptance Tests
(3)
(4)
Life Tests
4.2
Preproduction Tests - Preproduction tests shall be made on an equipment
representative of the production equipments to be supplied under the contract. Preproduction
tests shall be accomplished under the responsibility of the contractor and shall be conducted
in accordance with the approved test procedure of 4.6. The government inspector and the
proccuring activity shall be advised when tests are to be conducted so that a representative
may be designated to witness or supervise the tests when so desired. Contractors not having
adequate facilities to conduct all required tests shall obtain the services of a commercial
testing laboratory acceptable to the Government.
Preproduction Test Data - The contractor shall submit all data collected
4.2.1
in conducting these tests to the procuring agency for review and approval. On first pro-
duction contracts this data shall include a list of all electrical and electronic parts giving
their specified voltage, current and temperature rating and the applied circuit voltage,
current and ambient and surface temperatures. The ambient and surface temperature shall
be obtained under the extreme high temperature operating condition.
.
Scope of Tests - Preproduction tests shall include all tests deemed
4.2.2
necessary by the procuring activity to determine that the equipment meets all the require-
ments\of this specification and the contract: Preproduction tests shall include environ-
mental tests in accordance with the procedures of Specification MIL-T-5422 and interference
tests in accordance with Specification MIL-I-6181.
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals