 |
|||
|
|
|||
| ||||||||||
|
|  MIL-A-85116(AS)
3.4.1 Test reports, When specified in the contract, test reports conform-
ing to MIL-STD-831 shall be prepared for all preproduction tests required by
this specification. Unless otherwise specified in the contract, test reports
of quality conformance testing shall be prepared for the delivered hardware
(see 6.2.2).
3.5 Workmanship. The actuator shall be uniform in quality, free from cold
soldering, corrosion, pits, cracks, dents, rough edges and defects that will
affect life, configuration, serviceability or appearance. Workmanship shall
be in accordance with MIL-STD-454, Requirement 9.
QUALITY ASSURANCE PROVISIONS
4.
4.1 Responsibility for inspection. Unless otherwise specified in the
contract (see 6.2.1), the contractor is responsible for the performance of
all inspection requirements as specified herein. Except as otherwise
specified in the contract (see 6.2.1), the contractor may use his own or
any other facilities suitable for the performance of the inspection require-
ments specified herein, unless disapproved by the Government. The Government
reserves the right to perform any of the inspections set forth in the speci-
fication where such inspections are deemed necessary to assure supplies and
services conform to prescribed requirements.
4.1.1 General. Inspections shall be performed on the individual lots as
specified herein. The procuring activity reserves the right to delete,
modify, or vary the frequency of tests or require additional tests if nec-
essary to ensure compliance with this specification, the drawings, or the
contract. Unless otherwise specified herein, all tests are classified as
MAJOR. Failure of any actuator to conform with any requirement of this
specification shall cause rejection of that component.
4.1.1.1 Classification of inspections.
The inspection requirements speci-
fied herein are classified as follows:
(a) preproduction inspections (see 4.1.2).
(b) Quality conformance inspections (see 4.2).
(1) Individual tests (see 4.2.2).
(2) Lot sampling tests (see 4.2.2.2).
4.1.2 Preproduction inspections. The preproduction inspections shall
consist of the tests of Table I in the sequence shown (see 4.1.2.1).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals