10 October 1986
ACTUATOR, ELECTROMECHANICAL, LINEAR
This specification is approved for use within the Naval Air Systems
Command, Department of the Navy, and is available for use by all
Departments and Agencies of the Department of Defense.
1.1 Scope. This specification establishes the requirements for the
manufacture and inspection of one type of electromechanical linear actuator.
The test limits in this specification define minimum acceptable capabilities.
2. APPLICABLE DOCUMENTS
2.1.1 Specifications and standards. The following specifications and
standards form a Part of this specification to the extent specified herein.
Unless otherwise specified, the-issues of these documents shall be those
listed in the issue of the Department of Defense Index of Specifications and
Standards (DODISS) and supplement thereto, cited in the solicitation.
Testing, StOre Suspension and Release Equipment,
General Specification for
Electronic and Electrical Equipment, Accessories and
Repair Parts, Packaging and Packing of
Beneficial comments, recommendations, additions, deletions) and
any pertinent data which may be of use in improving this document
should be addressed to the Naval Air Engineering Center, Systems
Engineering and Standardization Department (Code 93), Lakehurst,
NJ 08733-5100, by using the selfaddressed Standardization
Document Improvement Proposal (DD Form 1426) appearing at the end
of this document or by letter.
Approved for public release; distribution is unlimited.
DISTRIBUTION STATEMENT A.