INCH - POUND
11 February 1991
30 September 1986
BEARINGS AND BUSHINGS, BRASS AND BRONZE, MACHINED OR FORMED
This specification is approved for use by the U.S. Army Missile Command,
Department of the Army, and is available for use by all Departments and Agencies of
the Department of Defense.
1.1 Scope. This specification covers bearings and bushings of brass and bronze,
machined or formed.
2. APPLICABLE DOCUMENTS
2.1 Government documents.
2.1.1 Specifications, standard, and handbooks. The following specifications,
standards, and handbooks form a part of this document to the extent specified herein. Unless
otherwise specified, the issues of these documents are those listed in the issue of the
Department of Defense Index of Specifications and Standards (DODISS) and supplement
thereto, cited in the solicitation (see 6.2).
Beneficial comments (recommendations, additions, deletions) and any pertinent data which
may be of use in improving this document should be addressed to: Commander, US Army
Missile Command, ATTN: AMSMI-RD-SE-TD-ST, Redstone Arsenal, AL 35898-5270 by
using the Standardization Document Improvement Proposal (DD Form 1426) appearing at the
end of this document or by letter.
DISTRIBUTION STATEMENT A.
Approved for public release; distribution