Click here to make tpub.com your Home Page

Page Title: Quality Assurance Provisions
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Table I. Rate of lift.
Up
Bulldozer Kit, Earth-Moving: Tank Mounting, M9
Next
Government verification



img
MIL-B-45390A(AT)
3.5 Identification marking. When specified (see 6.2), the bulldozer kit shall be marked as
specified by the procuring activity in accordance with MIL-STD-642 (see 4.6.2).
3.5.1 Nameplate. A nameplate conforming to the applicable drawing shall be provided
(see 4.6.2).
3.6 Finish. Unless otherwise specified on the applicable drawing, the Bulldozer Kit's
component assemblies and parts shall be prepared and painted in accordance with MIL-STD-193
(see 4.6.2).
3.7 Workmanship. Workmanship shall be of a quality to assure that the bulldozer kit and its
components are free of defects that compromise, limit, or reduce capability in the performance of
its intended use. Electric leads and hydraulic lines shall be located in a manner so as to prevent
possible damage by rubbing on adjacent lines or appendages. There shall be no loose, damaged,
or missing assemblies, components, or attaching hardware. All moving parts shall operate
without sticking or binding (see 4.6.2).
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract or purchase
order (see 6.2), the contractor is responsible for the performance of all inspection requirements as
specified herein. Except as otherwise specified in the contract or purchase order, the contractor
may use his own or any other facilities suitable for the performance of the inspection
requirements specified herein, unless disapproved by the Government. The Government
reserves the right to perform or witness any of the inspections set forth in the specification where
such inspections are deemed necessary to assure supplies and services conform to prescribed
requirements.
4.1.1 Responsibility for compliance. All items must meet all requirements of sections 3
and 5. The inspection set forth in this specification shall become a part of the contractor's overall
inspection system or quality program. The absence of any inspection requirements in the
specification shall not relieve the contractor of the responsibility of assuring that all products or
supplies submitted to the Government for acceptance comply with all requirements of the
contract. Sampling in quality conformance does not authorize submission of known defective
material, either indicated or actual, nor does it commit the Government to acceptance of
defective material.
4.1.2 Inspection equipment. Unless otherwise specified in the contract (see 6.2), the
contractor is responsible for the provision and maintenance of all inspection equipment necessary
to assure that supplies and services conform to contract requirements. Inspection equipment
must be capable of repetitive measurements to an accuracy of 10 percent of the measurement
tolerance. Calibration of inspection equipment shall be in accordance with MIL-STD-45662.
5

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.
9438 US Hwy 19N #311 Port Richey, FL 34668

Phone For Parts Inquiries: (727) 755-3260
Google +