4.5 Quality conformance inspection.
18.104.22.168 Lot formation. An inspection lot shall consist of all the bulldozer kits of one type
and part number, from an identifiable production period, from one manufacturer, submitted at
one time for acceptance.
22.214.171.124 Sampling for examination. Samples for quality conformance examination shall be
selected in accordance with general inspection level II of MIL-STD-105. Before sampling may
be initiated, the contractor shall establish by examination of at least 3 consecutively produced
bulldozer kits that the process average percent defective, as defined in MIL-STD-105, is not
greater than the specified AQLs.
126.96.36.199 Acceptable quality level. Each sample selected in accordance with 188.8.131.52 shall be
examined to determine conformance to the following acceptable quality levels (AQLs).
184.108.40.206 Classification of defects. For examination purposes, defects shall be classified as
listed in table III.
TABLE III. Classification of defects.
AQL 25 defects/100 units
Assembly, incomplete (see 3.3).
Dimensions affecting interchangeability, not within tolerance
Right angle drive, pump, and coupling; improper assembly.
Front mounting brackets and moldboard; improper weld or
Headlamps and guards; improper assembly, inoperative or
Control assembly and guards; improper assembly, damaged,
malfunction, or improper weld.
Installation fixture and templates; damaged or missing.
Hydraulic cylinders, reservoir, filter, hoses, pipes, and
guards; improper assembly, malfunction, leaks or improper