 |
|||
|
|
|||
| ||||||||||
|
|  MIL-B-48447A(MU)
4.2 First article (initial production) approval. - The requirement
for first article approval and the responsibility (Government or contrac-
tor) for first article testing shall be as specified in the contract.
The sample for first article approval tests shall consist of three body
assemblies plus three each of all items covered by SQAP. The sample
shall be manufactured in the same manner, using the same materials,
equipment, processes, and procedures as used in regular production. All
parts and materials, including packaging shall be obtained from the
same source of supply as used in regular production.
4.2.1 Government testing. - When the Government is responsible for
conducting first article approval tests, the contractor, "prior to sub-
mitting the sample to the Government,. shall inspect the sample to insure.
that it conforms to all the requirements of the contract and-submit a
record of this -inspection with the sample, including certificates of
conformance for materials.
4.2.2 Contractor testing. - When the contractor is responsible for
conducting first article approval tests, the sample shall be inspected by
the contractor for all the requirements of the contract. The sample
and a record of this inspection, including certificates of conformance
for materials, shall be submitted to the Government for approval. The
Government reserves the right to witness the contractor's inspection.
4.3 Inspection provisions.
4.3.1 Submission of product. - Unless otherwise specified by the
contracting officer, inspection lot formation and presentation
of lots shall be in accordance with "Submission of product" provisions
of MIL-STD-105.
4.3.2 Examination and tests.
4.3.2.1 Components and subassemblies.- All components and subassem-
blies shall be inspected in accordance with the inspection provisions con-
tained in Supplementary Quality Assurance Provisions (SQAP) listed in the
technical data package (TDP). In the absence of SQAP'S, the applicable
Quality Assurance Provisions of MIL-F-13926 shall apply.
4.3.2.2 Body Assembly. - Examination and tests related to Section 3
herein shall be performed on a single defect (individual characteristic)
basis in accordance with MIL-STD-105 and the sampling plans specified
in table I, II, III, and IV herein. Examination and tests for packaging,
packing and marking shall be in accordance with MIL-P-14232 and Section 5
herein. In addition to 100% inspection as specified in 4.3.2.3, the tabu-
lated classification of defects in Tables I, II, III and IV shall consti-
tute the minimum inspection to be performed by the supplier after first
article approval and prior to Government acceptance or rejected by item
or lot.
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals