 |
|||
|
Page Title:
Contractor furnished inspection equipment |
|
||
| ||||||||||
|
|  MIL-B-48447A(MU)
4.4.4 Failure of samle. - Should any one item of a special sampling .
fail to meet the specified test requirements, acceptance of the represented
inspection lot shall be suspended by the Government until necessary correc-
tions have been made by the contractor and the resubmitted items have been
approved (see 4.3.3).
4.5 Inspection equipment. - "Except as otherwise provided for by the
contract, the contractor shall supply and maintain inspection equipment in
accordance with the applicable requirements of MIL-I-45607.
4.5.1 Government furnished inspection equipment. - Where the contract
provides for Government furnished test equipment, supply and maintenance
of test equipment shall be in accordance with applicable requirements
specified in MIL-I-45607."
4.5.2 Contractor furnished inspection equipment.
4.5.2.1 Government design. - All inspection equipment specified by
drawing number in specifications or SQAP forming a part of the technical
data included in the technical data package list.
4.5.2.2 Contractor design. - The contractor shall design and supply
inspection equipment compatible with the "Test Methods and Procedures"
specified in 4.6 of this specification and with the component inspection
-
procedures specified in "Examination" and ''Test Facilities" requirements
of MIL-F-13926. Since tolerance of test equipment is normally considered
to be within 10% of the product tolerance for which it is intended, this
inherent error in the test equipment design must be considered as part of
the prescribed product tolerance limit. "Thus, concept, construction,
materials, dimensions and tolerances used in the design of test equipment
shall be so selected and controlled as to insure that the test equipment
will reliably indicate acceptability-of a product which does not exceed
90% of the prescribed tolerance limit, and permit positive rejection when
non-conforming. Construction shall be such as to facilitate routine
calibration of test equipment. "
4.5.2.3 Inspection equipment design requirements.
4.5.2.3.1 Sealing. - Special testing equipment to test sealing of
the body assembly shall conform to the internal pressure test requirements
of Drawing F8565556, Pressure Tester-Two Station.
4.5.2.3.2 Performance. - Special test equipment to determine per-
formance of the body assembly shall conform to the requirements of
Drawing F11746735 (Fixture, Alignment).
4.5.2.3.2.1 Interchangeability.- Maximum and minimum interchange-
ability gages shall conform to Drawings F11732109 and F11732110 respectively.
4.6 Test methods and procedures.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals