 |
|||
|
Page Title:
Examination for length of individual rolls |
|
||
| ||||||||||
|
|  MIL-C-24757(SH)
The lot shall be unacceptable if the points per 100 square yards (83.6 square meters) of the total
yardage examined exceeds 50 points. The lot shall be unacceptable if the individual points per 100
square yard (83.6 square meters) of two or more individual rolls exceeds 75 points. If one roll
exceeds 45 points per 100 square yards (83.6 square meters), a second sample, the same size as the
final sample, shall be examined only for individual roll quality examination. The lot shall be
unacceptable if one or more rolls in the second sample exceeds 45 points per 100 square yards
(83.6 square meters). Point computation for lot quality and individual roll quality shall be as
follows: l
=
Points per 100 square yards (83.6 square
Total points scored in sample x 3600
meters)
Contracted width of cloth (inches x
total yards inspected
4.4.1.2 Demerit points. Demerit points shall be assigned as follows:
= one point
For defects 3 inches (7.6 cm) or less in any dimension
For defects exceeding 3 inches (7.6 cm) but not exceeding
= two points
6 inches (15.2 cm) in any dimension
For defects exceeding 6 inches (15.2 cm), but not exceeding
= three points
9 inches (22.0 cm) in any dimension
= four points
For defects exceeding 9 inches (22.0 cm) in any dimension
The following defects, when present in the yard-by-yard and overall examination, shall be scored
four points for each yard (0.9 meter) in which they occur:
a. Baggy, ridgy, or wavy cloth
b. Width less than specified
c. Uneven weaving
d. Objectionable odor
e. Overall uncleanness or discoloration
f. character of finish not equal to standard sample of first article when applicable.
4.4.1.3 Examination for length of individual rolls. The individual roll shall be exam.ined for
gross length and the number of pieces in the roll. Any gross length found to be more than 2 yards
below the gross length marked on the ticket or any roll found to contain more than one piece,
when applicable, shall be considered a defect with respect to length. The unit of product for this
examination shall be one roll. The sample unit for this examination shall be one roll (see 4.4.1).
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals