 |
|||
|
Page Title:
Quality assurance terms and definitions |
|
||
| ||||||||||
|
|  .
MIL-C-45525B(WC)
specified herein, unless disapproved by the Govrnment. The Government re-
serves the right to perform any of the inspections set forth in the specification
where such inspections are deemed necessary to assure that supplies and
services conform to prescribed requirements.
4.2 Quality assurance terms and definitions. Quality assurance terms and
definitions shall be as-specified in MIL-STD-109.
4.3 Classification of inspection. The inspection requirements specified
herein are classified as follows:
a. First article inspection (see 4.4.2)
b. Quality conformance inspection (see 4.5)
4.4 First article.
4.4.1 First article sample. A first article sample shall be submittd by the
contractor (in accordance with the contract requirements) for examination
by or for the Government and tests by or for the Government (see 6.1.1). The
sample shall be representative of the production process to be used during
quantity production.
4.4.2 First article inspection. The first article sample shall be subjected
to a first article initial production test in accordance with all quality
conformance inspection and all examinations and tests described in this spec-
ification to assure conformance with the requirements of this specification.
4.4.2.1 Failure of the first article sample to meet the requirements as
evidenced by the results of the examinations and tests shall be cause for
rejection (see 6.1.1). The contractor shall determine the cause of failure
and shall take corrective action in current and subsequent production. Re-
submission and retest shall be at the option of the Government (see 6.1.1).
4.4.2.2 Disposition of an acceptable first article sample shall be in
accordance with the provisions of the contract (see 6.1.1).
4.5 Quality conformance inspection.
4.5.1 Inspection provisions. Cannon shall be inspected for conformance to
requirements of the provisions of this specification, MIL-C-13931, SQAPS listed
in Master LSQAP 11577214, and SQAP-APPENDIX-WVT.
4.5.1.1 Final examination. Final examination of each cannon shall be completed
after testing and prior to preservation and packaging to determine compliance
with this specification, MIL-C-13931, and as specified in the contract.
4.5.1.2 Inspection approval stamp. The application of the inspection approval
stamp shall be as specified in MIL-C-13931.
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals