Cupola Body Assembly for Armored Vehicle Bridge Launcher, M60A1 and M48A5 Tank Chassis

Page Title: Cupola Body Assembly for Armored Vehicle Bridge Launcher, M60A1 and M48A5 Tank Chassis
Up | Next

Web
www.tpub.com

Information Categories

....

INCH-POUND

MIL-C-46793C(ME)

24 April 1992

SUPERSEDING

MIL-C-46793B (ME)

28 October 1983

MILITARY SPECIFICATION

CUPOLA BODY ASSEMBLY FOR ARMORED VEHICLE

BRIDGE LAUNCHER, M6OA1 AND M48A5 TANK CHASSIS

This specification is approved for use within the USA Belvoir Research,

Development, and Engineering Center, Department of the Army, and is available

for use by all Departments and Agencies of the Department of Defense.

1. SCOPE

1.1

Scope. This specification covers the cupola body assembly required

for the armored vehicle bridge launcher, M6OA1 and M48A5 tank chassis.

APPLICABLE DOCUMENTS

2.1

Government documents.

2.1.1 Specifications and standards. The following specifications and

standards form a part of this document to the extent specified herein. Unless

otherwise specified, the issues of these documents are those listed in the

issue of the Department of Defense Index of Specifications and Standards

(DoDISS) and supplement thereto, cited in the solicitation (see 6.2).

Beneficial comments (recommendations, additions, deletions) and any

pertinent data which may be of use in improving this document should be

addressed to: USA Belvoir Research, Development, and Engineering Center,

ATTN: STRBE-TSE, Fort Belvoir, VA 22060-5606 by using the

Standardization Document Improvement Proposal (DD Form 1426) appearing

at the end of this document or by letter.

AMSC N/A

FSC 5420

DISTRIBUTION STATEMENT A.

Approved for public release; distribution is

unlimited.

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business