 |
|||
|
Page Title:
Alternate pack for case, cartridge, M118. |
|
||
| ||||||||||
|
|  MIL-C-50446A(AR)
The case cartridge shall be packaged for shipment
5.1.2 Level B.
as described below:
5.1.2.1 Case, cartridge, M118. Five hundred (500) cases shall be
packed base down in five (5) layers in Type 1, Class 1, "B" Flute, 175
pound minimum, domestic class, RSC Style, Specification PPP-B-636
fiberboard box. Inside dimensions of fiber box shall be 13 3/4 X 18 3/4
X 9 3/4 high ( 1/16 tol). Each layer shall be composed of an egg
crate type separator in a 10 X 10 pattern. Separators shall fit snug
in fiber box, length and width. Height of separator to 1 1/2 inches.
A filler 18 X 18 shall be used between layers and on top as required
for tight packing. Material used for separators and fillers shall be
the same as that used for the fiber box.
5.1.2.2 Alternate pack for case, cartridge, M118. Three hundred
(300) cases shall be packed in six (6) layers in Type 1, Class 1, "B"
flute, 175 pound minimum, domestic class, RSC Style, Specification
PPP-B-636 fiberboard box. Inside dimensions of fiber box shall be
17 1/2 X 8 3/4 X 11 5/8 high. Each layer shall be composed of an egg
crate type separator in a 10 X 5 pattern. Separators shall fit snug in
fiber box, length and width. Height of separator to be 1 1/2 inches.
A filler 17 X 8 shall be used between layers, and on top as required
for tight packing. A spacer 8 5/8 X 8 5/8 shall be placed between
flaps on bottom and on top of fiber box. Material used for separator,
fillers and spacers shall be the same as that used for fiber box.
5.2 The construction of the fiber box and the material
requirements of the fiber box shall comply with PPP-N-636. When
assembled, the corrugations of the fiber box shall parallel the fiber
box depth. The manufacturer's joint on the fiber box shall be
reinforced with paper tape or metal stapled or stitched.
Spacing of staples or stitches shall not average over 1 1/2 inch
apart, center to center. A manufacturing tolerance of plus or minus
1.8 inch is permissible. The parts manufacturing so that proper fit of
packing material dimensions provide a proper fit of all parts, as
determined to be necessary by examination of sample packs, are
permissible.
5.3 Sealing. The fiber box shall be secured with gummed Kraft
paper not less than 3 inches wide, comply with PPP-T-45, Grade B Tape.
The tape shall be centered the full length of the outer flap seams and
extend over each end of the fiber box at least 3 inches. The flap edge
seams shall be similarly sealed with the tape extending at least 3
inches along the corners of the fiber box. Tape shall be properly
moistened and sufficiently compressed to insure tight adhesion to the
fiber box.
11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals