 |
|||
|
Page Title:
Submission of inspection equipment design for approval |
|
||
| ||||||||||
|
|  MIL-C-50446A(AR)
Marking of the fiber box shall comply with
5.4 Marking.
MIL-STD-1169.
Unitization shall be as required by the
5.5 Unitization.
procuring agency.
5.6 Shipping. When shipments from more than one lot are shipped
as a carload, each lot shall be kept separate, and the division between
lots clearly indicated to prevent mixing of the lots in transit.
NOTES
6.
6.1 Intended use. The component covered by this specification is
intended for use with 40MM ammunition.
6.2 Ordering data. See MIL-A-48078.
6.3 Submission of inspection equipment design for approval. See
MIL-A-48078. Submit equipment designs as required to Commander,
ARRADCOM, ATTN: DRDAR-QAA-I, Dover, NJ 07801. Request letter of
submittal state contractor, contract number, specification number, item
nomenclature and classification of defects or test paragraph.
6.4 Submission of results of contractor-conducted examinations and
tests. Unless otherwise specified by the Contracting Officer, the
contractor shall forward requested records of examinations or tests to
Commander, ARRADCOM, ATTN: DRDAR-QAA-S, Dover, NJ 07801.
6.5 If the requirement cannot be met in the free state, to "go"
inside diameter plug gage may be inserted in the cartridge case while
inspecting the "go" and "no go" second largest outside diameter. If
the "go" inside diameter plug is utilized, the data cards shall be
annotated accordingly.
6.6 If the requirement cannot be met in the free state, a
confining fixture may be utilized while inspecting the "go" and "no go"
largest inside diameter. If the confining fixture is utilized, the
data cards shall be annotated accordingly.
6.7 Metal defective. Nick, crack, dent or sharp edges which might
interfere with the proper assembly or end item performance of the item.
12
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals