 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-50740(MU)
8 August 1973
4.5.2.2 Contractor design. The contractor shall design and supply
inspection equipment compatible with the test methods and procedures
specified in 4. 6 of this specification and with the component inspection pro-
cedures specified in examination and test facilities provisions of MIL-F-
13926. Since tolerance of inspection equipment is normally considered to be
within 10 percent of the product tolerance for which intended, this inherent
error in the inspection equipment design must be considered as part of the
prescribed product tolerance limit. Thus, concept, construction, materials,
dimensions, and tolerances used in the design of inspection equipment shall
be so selected and controlled as to insure that the inspection equipment will
reliably indicate acceptability of a product which does not exceed 90 percent
of the prescribed tolerance limit and permit positive rejection when noncon-
forming. Construction shall be such as to facilitate routine ca~ibration of
inspection equipment.
TABLE V
INSPECTION EQUIPMENT
4.6 Test methods and procedures.
4.6.1 Test conditions. Unless otherwise specified, the test condi-
tions shall be in accordance with the test facilities provisions of
MIL-F-13926.
4.6.1.1 Inition conditions. Apply the loads, interconnection, and
power to the assembly as specified in table I.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals