 |
|||
|
Page Title:
Contractor-furnished inspection equipment. |
|
||
| ||||||||||
|
|  MIL-C-50742(MU)
8 August 1973
TABLE VI
INSPECTION EQUIPMENT'
4.5.1 Government-furnished inspection equipment. Where the
contract provides for Government furnished inspection equipment,
supply and maintenance of inspection equipment shall be in accordance
with the applicable requirements of MIL-I-45607.
4.5.2 Contractor-furnished inspection equipment.
4.5.2.1 Government design. Unless otherwise specified in the
contract, all inspection equipment specified by drawing number in speci-
fications or SQAPS forming a part of the contract shall be supplied by
the contractor in accordance with applicable technical data listed in
the TDP.
4.5.2.2 Contractor design. The contractor shall design and
supply inspection equipment compatible with the test methods and
procedures specified in 4.6 of this specification and with the
component inspection procedures specified in examination and test
facilities provisions of MIL-F-13926. Since tolerance of inspection
equipment is normally considered to be within 10 percent of the product
tolerance for which intended, this Inherent error in the lnspect~on
equipment design must be considered as part of the prescribed product
tolerance limit. Thus, concept, construction, materials, diimensions,
and tolerances used in the design of inspection equipment shall be so
selected and controlled is to insure that the inspection equipment will
reliably indicate acceptability of a product which does not exceed 90
percent of the prescribed tolerance limit and permit positive rejection
when nonconforming. Construction shall be such as to facilitate
routine caibration of inspection equipement.
11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals