 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-60985A (MU)
5.2 Packing.-
5.2.1 Level C. -The metal parts for Case, Cartridge, M118, preserved
and packaged as specified in 5.1.1, shall be packed for shipment as described
below:
Case, Cartridge, M118. -See 5.1.1.1 or 5.1.1.3.
5.2.1.1
Base plug and powder charge cup. -See 5.1.1.2.
5.2.1.2
5.3 The construction of the fiber box and the material requirements of
the fiber box shall comply with PPP-B-636. When assembled, the corrugations
of the fiber box shall parallel the fiber box depth. The manufacturer's
joint on the fiber box shall be reinforced with paper tape or metal stapled
or stitched.
Spacing of staples or stitches shall not average over 1 1/2 inches apart,
center to center. A manufacturing tolerance of plus or minus 1/8 inch is
permissible. The parts manufacturer shall be furnished pre-production samples
of all packing materials so that proper fit of packing material dimensions
provide a proper fit of all parts, as determined to be necessary by examination
of sample packs, are permissible.
5.4 Sealing. -The fiber box flaps shall be secured with gummed Kraft paper
not less than 3 inches wide, complying with PPP-T-45, Grade B. Tape. The tape
shall be centered the full length of the outer flap seams and extend over each
end of the fiber box at least 3 inches. The flap edge seams shall be similarly
sealed with the tape extending at least 3 inches along the corners of the
fiber box. Tape shall be properly moistened and sufficiently compressed to
insure tight adhesion to the fiber box.
5.5 Marking. -Marking of the fiber box shall comply with MIL-STD-1169
5.6 Shipping. -When shipments from more than one lot are shipped as a
carload, each lot shall be kept separate, and the division between lots clearly
indicated to prevent mixing of the lots in transit.
6.
NOTES
6.1 Ordering data. -Procurement documents shall specify the following:
a. Title, number and date of this specification,
b. Data cards shall be prepared for each lot in accordance with the
information specified in Standard MIL-STD-1167.
c. Provisions for submission of first article samples.
12
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals