 |
|||
|
Page Title:
Quality conformance inspection. |
|
||
| ||||||||||
|
|  MIL-C-62205B(AR)
4.5 Quality conformance inspection.
4.5.1 Procurement conditions. The following inspection plans shall l pply
where the assembly is procured for use us a:
Plan
Use
a. Logistics spare assembly apart
A and C
from the next higher assembly
B and C
b. Component assembly of the next
higher aasembly.
4.5.2 Inspection plan A.
4.5.2.1 General sample and tests. One assembly, as a control sample,
shall be selected at random by the Government representative frm each 100
assemblies produced and shall be subjected to all the tests in table III.
4.5.2.2 Environmental sample and tests. Three assemblies, as a control
sample shall be selected at random by the Government representative from each
50 assemblies produced or from each month's production, whichever occurs first.
All the tests in table IV shall be applied separately to each asmably in the
sample.
4.5.2.3 Acceptance. Where any one asstily of either sample fails to
meet any speclfled requirement the lot shall be rejected. Rejected lots
shall be subject to the provisions of MIL-STD-105.
4.5.3 Inspection plan B.
4.5.3.1 Sample and tests. The sumple shall be selected by the Gove~nt
representative m accordance with the provisions of MIL-STD-105. All the
tests in table III and only the test of item 307 iu table IV shall be applied.
4.5.3.2 Acceptance. Where any one assembly fails to meet any specified
requirement, the defective amsambly shall be removed from the lot and
resubmitted only after all defects have been corrected.
4.5.4 Inspection plan C.
4.5.4.1 Sample and tests. Each assembly in every lot shall be subjected
to all the tests m table II and shall be examined visually for completeness,
improper assembly and evidence of poor workmanship.
16
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals