 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-64025(AR)
3.6.12 STORE
mode.
3.6.12.1
Power on prompt .
When a valid STORE code has been
established and the store code select switch is off, the RCU shall
display "0N", after the unit power switch is turned on when tested per
4.5.2.6. .
3.6.12.2 Invalid STORE code entry. The RCU shall display
"Invalid" 16 + 1.0 seconds after the unit power switch is turned on if
an incorrect or incomplete STORE code or no entry is keyed in on the
keyboard within the first 15 seconds after the unit power switch has
been turned on when tested per 4,5.2.7
3 .6.12.3 No Previous SEND code selected.
The RCU shall display
four dashes (---- ) 16 + 1.0 seconds after the unit power switch is
turned on if a SEND code has not been previously selected and the
correct STORE code has been keyed in within the first 15 seconds after
the unit power switch has been turned on when tested per 4.5.2.8
3.6.13 SEND code selection.
The RCU permits a four digit SEND
code to be selected, from pseudo-randomly generated candidate codes,
via the front panel keyboard. The RCU shall display "AUTO" when the
AUTO key is pressed and the RCU is in the STORE modej then the RCU
shall display a four digit SEND code when the TRANSFER key is pressed
sequentially following the AUTO key when tested per 4.5.2.10.
Repeating this sequence will select a different SEND code.
3.6 .13.1
Previous SEND code selected.
The RCU shall display the
previously selected SEND code 16 + 1.0 seconds after the unit power
switch is turned on if a SEND code has been previously selected and
the correct STORE code has been keyed in within the first 15 seconds
after the unit power switch has been turned on when tested per
4.5.2.11
3.6.14
Transfer
capability.
The RCU shall have the capability
--
.
of transferring the Remote Copy Data (RCD) code from RCU to RCU via
the Magnetic Coupling Device (MCD) coil.
The receiving and
transferring of data is accomplished when both RCUS are in the STORE
mode, and the MCD transfer coils are aligned.
3.6.14.1
RCD code transfer.
a
3.6.14.1.1 Transfer output prompt .
The RCU shall display "COPY
when the COPY key is pressed and the RCU is in the STORE mode when
tested per 4.5.2.12.
3.6.14.1.2 Data sending display.
When the TRANSFER key is
pressed sequentially following the COPY key while in the STORE mode,
the RCU shall display "SENDING" when tested per 4.5.2.12
9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals