 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-70741 (AR)
W/AMENDMENT 2
solicitation. Unless otherwise specified, the issues of documents not listed in the DODISS
are the issues of the documents cited in the solicitation (see 6.2).
AMERICAN SOCIETY FOR TESTING AND MATERIALS
ASTM D2240
-
Indentation Hardness of Rubber and Plastics by
Means of Durometer, Standard Method of Test for
(DoD adopted)
ASTM D3951
-
Commercial Packaging, Practice for (DoD adopted)
ASTM E8
-
Tension Testing of Metallic Materials, Standard
Method of
ASTM E18
-
Rockwell Hardness and Rockwell Superficial
Hardness of Metallic Materials, Test for
(Copies of ASTM standards are available online at http://www.astm.org or from
American Society for Testing and materials, 100 Barr Harbor Drive, West
Conshohocken, PA 19428-2959.)
2.3 Order of precedence. In the event of a conflict between the text of this
document and the references cited herein, the text of this document shall take precedence.
Nothing in this document, however, shall supersede applicable laws and regulations
unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Materials. Materials and parts shall be in accordance with applicable drawings
and specifications.
3.2 Containers. The containers (container assemblies) shall comply with all
requirements specified on drawing 9378166 and associated drawings and with all
requirements specified in applicable specifications and standards.
3.3 Welding. The welding shall comply with the requirements of MIL-W-12332
or MIL-STD-1261.
3.3.1 Tensile strength of body weld. The tensile strength of the longitudinal weld
shall not be less than 65 percent of the tensile strength of body material.
3.3.2 Tensile strength of body material. The tensile strength of the body material
shall not be less than 50,000 pounds per square inch (psi).
3.4 Painted surface. The painted surfaces of the container shall comply with the
requirements of TT-C-490. However, the film thickness and salt spray requirements of
TT-C-490 shall not apply to the interior surfaces, exterior surface welded spots and
exterior surface sharp corners of the container. Bare spots are permissible on all bearing
surfaces.
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals