 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-70741 (AR)
W/AMENDMENT 2
weldments (container bodies) are procured separately, the contractor shall submit for Government
approval, the test procedure that will be followed to meet the applicable test requirement.
4.5.6.2.1 Screw torque test. After the air pressure is performed and the screw is reapplied to the
cover assembly, apply the minimum torque (see Dwg. 9378166). Any evidence of motion of the screw
before reaching the minimum acceptable torque shall be cause for rejection of the container assembly
being tested. Any container assembly which fails the screw torque test may be reworked and returned
to the lot after passing the screw torque test.
5. PACKAGING
5.1 Packaging requirements. None required.
5.2 Packing. Packing shall be commercial. Metal ammunition containers shall be prepared in
accordance with ASTM-D3951.
5.2 Marking. Shipping marking shall comply with ASTM-D3951 and the following additional
instructions. No shipping marking shall be placed directly on the containers. Commercial shipping
tags attached with wire shall be used unless otherwise specified. The following information shall be
shown: Item name and model number, part number and revision, contract number, lot number and
date, name and address of manufacturer. If containers are bundled, boxed or palletized, the gross
weight and quantity shall be included. The above information may be placed on pallets or boxes by
labeling or stenciling.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is
not mandatory.)
6.1 Intended use. This 'lightweight metal ammunition container is used for packing 105MM
howitzer ammunition and 105MM tank ammunition.
6.2 Acquisition requirements. See MIL-A-48078.
6.3 Submission of inspection equipment for design approvals. See MIL-A-48078. Submit
designs as required to: Commander, U.S. Army Armament Research, Development and Engineering
Center, ATTN: AMSMC-QAR-I (D), Picatinny Arsenal, NJ 07806-5000. This address will be
specified on the Contract Data Requirements List, DD Form 1423 in the contract. Unless otherwise
specified, data item D1-R-1714 will apply.
6.4 Equivalent test methods. Prior approval of the Contracting Officer is required for use of
equivalent test methods. A description of the proposed method should be submitted through the
Contracting Officer to: Commander, U.S. Army Armament Research Development and Engineering
Center, ATTN: AMSMC-QAR-Q (D), Picatinny Arsenal, NJ 07806-5000. This description should
include but not be limited to the accuracy and precision of the method, test data demonstrating the
accuracy and precision and drawings of any special equipment required.
31
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals