 |
|||
|
Page Title:
Table 2. Mileage and speed tests. |
|
||
| ||||||||||
|
|  MIL-D-52923B(ME)
129.
Air brake system not as specified.
3.8.5
130.
Gladhands not as specified.
3.8.6
131.
Electrical system not as specified.
3.8.7,
3.8.8,
3.8.9
132.
Lubrication not as specified.
3.9 thru
3.9.4
133.
Slinging and tiedown provisions not as specified.
3.10, 3.11
134.
Painting, marking and data plate not as specified.
3.2, 3.8,
3.12, 3.14,
3.15 and
3.16
135.
Toolbox not as specified.
3.13
136.
Technical publications, repair parts, and
3.17, 3.18
maintenance tools not as specified.
137.
Workmanship not as specified.
3.20
138.
Welding not as specified.
3.19.1
139.
Certification not as specified.
3.6, 3.22
4.5.2 Test.
4.5.2.1 Production run-in. Start and operate each distributor for a period not less than one hour to
assure operation of all components and to allow for minor adjustments. All controls shall be manipulated.
Evidence of leakage, malfunction, permanent deformation or inability of the distributor to operate as
specified shall constitute failure of this test.
4.5.2.2 Travel. The distributor, with lights on, shall be operated as specified in table II. The
distributor shall be completely assembled and serviced. Test course or area shall be selected by the
contractor. Evidence of malfunction, permanent deformation or damage shall constitute failure of this test.
TABLE II. Mileage and speed tests.
Type of course
Mileage and Speed
Payload
100 miles at variable speeds up to 50 mph
Max. payload
Primary highway
W/o payload
100 miles at variable speeds up to 50 mph
Primary highway
Max. payload
50 miles at variable speeds up to 30 mph
Unpaved road
W/o payload
50 miles at variable speeds up to 30 mph
Unpaved road
Max. payload
Loose fill
25 miles at variable speeds up to 5 mph
W/o payload
Loose fill
25 miles at variable speeds up to 5 mph
4.5.2.3 Axle and suspension check. To determine conformance to 3.8.3, 3.8.3.1, and 3.8.3.3, the
complete suspension system and components shall be checked for proper assembly, installation; whenever
seals are used, they shall be checked for proper installation as required to preclude leakage of lubricants
and entrance of foreign matter into bearings. Failure to conform to 3.8.3, 3.8.3.1, and 3.8.3.3 shall
constitute failure of this test.
19
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals