 |
|||
|
|
|||
| ||||||||||
|
|  MIL-D-63303B(AR)
TABLE VI
500 MILE TEST
(804.5 Kilometer)
FUNCTIONS
MILEAGE & TOWING SPEEDS
COURSE
Normal or average
a.
200 miles (322 km) at avg.
Hard Surface
stops twenty (20)
speed of thirty-five (35)
times.
mph. (56.3 kmph)
b.
Quick stops from a
speed of at least
twenty (20) mph
(32.2 kmph) by
instantaneous
application of full
service (prime
`mover) braking
power, ten (10)
times.
Sharp right and
c.
sharp left turns,
ten (10) times each
250 miles (402 km) at
Secondary
speeds applicable "to
Roads
conditions of terrain.
50 miles (80 km) at speeds
off-
applicable to conditions
Road
of terrain.
Ninety (90) Percent of the mileage specified for each
NOTE:
course shall-be performed with payload. The remaining
ten (10) percent of the mileage shall be performed
without payload.
4.4.4 Mine mission test. After completion of the 500 mile test
at APG, the M128 Mine Dispenser will complete a five (5) day
mission, consisting of laying four (4) 1000 meter minefield during
each twenty-four hour period. During each minefield mission, mines
will be dispensed for a period of 2.4 hours which includes time for
loading and reloading and approximately ten (10) miles of on-road
and two (2) miles of off-road (cross country) travel. (Approx. 1000
mines/minefield using all density settings).
4.4.5 Test failure. Failure of the dispenser to comply with
any of the requirements specified, or any deficiency of a
workmanship or materials nature found on the dispenser during, or as
a result of the five hundred (500) mile (804.5 Km) test, shall be
cause for rejection of the dispenser. Where the failure is
attributable to a deficiency of a workmanship or materials nature,
the Government will discontinue acceptance of production dispenser
until evidence has been provided by the manufacturer that corrective
action has been taken to eliminate the deficiency.
24
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals