Click here to make tpub.com your Home Page

Page Title: Visual and mechanical inspection.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-D-70484(AR)
4.5.3 Testing.  The tests (First Article and Quality
Conformance) listed herein, shall be performed on inspection lots
as defined in 4.5.1 of this specification.  The sampling plans
shall conform to the provisions of 4.5.2 above.
4.5.4 Inspection equipment.  The inspection equipment
required to perform the inspections and tests prescribed in this
specification is identified in the "Paragraph Reference/Inspection
column in the tables, starting with paragraphs 4.5.2.1 and test
methods paragraph (see 4.6).  The contractor shall submit for
approval inspection equipment designs in accordance with the terms
of the contract.  See 6.3 herein.
4.6 Methods of inspection.
4.6.1 Materials, components and processes.  Compliance with
all requirements of Section 3 of this specification shall be
ascertained by current and continuing examination of inspection
and test data to determine that all components (parts, sub-
assemblies, and materials) have been inspected and tested and
found to comply with their respective drawing and specification
requirements, and that all specified manufacturing processes have
been followed.
4.6.1.1 Visual and mechanical inspection.  The visual, manual
and mechanical inspections and tests shall verify compliance with
the requirements of Sections 3 and 5 of this specification in
accordance with 4.5.2 and Table IV.
4.6.2 Performance test.  The Display Unit shall be tested for
compliance with specified performance requirements after being
subjected to the preconditioning requirement (see 3.4.2).  Any
M138 Display Unit which fails to comply with the specified
requirement or evidence of degradation of its operation shall be
classed defective.  Test equipment and procedure shall be
satisfactory to the contracting officer (see 4.5.4).
4.6.3 Interchangeability (first article inspection only).
The Display Unit shall be subjected to the interchangeability
tests specified (see 3.4.1).  at the discretion of the Government
representative,  an interchangeability retest may be allowed.
Failure during the retest shall cause rejection of the first
article.  A sample of five Operation Units from each retest shall
be tested using the same procedures specified.
4.6.4 Proof test (first article inspection only).  When
specified in the contract (see 6.2) one (1) M138 Display Unit
shall be forwarded to the site specified by the contracting agency
and utilized on an AH-1S helicopter to determine that the test set
will function properly within the system.  The test sets shall
function in accordance to the intent of the design and with no
evidence of malfunction.
22

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business