Click here to make tpub.com your Home Page

Page Title: Visual and dimensional examination
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-E-23765B(SH)
4.5.4.6  Sampling for weld tests.  Sufficient quantity of electrodes or
shall be selected from each lot (see 4.5.1.1) for use in the preparation
of such welds as may be required in the detail specification.
4.5.5 Sampling for SAW flux.
4.5.5.1 Sampling for examination of filled containers.  A random sample
of filled containers shall be selected from each lot in accordance with
MIL-STD-105, inspection level I, acceptable quality level (AQL) of 2.5 percent
defective, to verify compliance with this specification regarding fill, closure,
marking, and any other requirements not involving tests.
4.5.5.2 Sampling for weld test.  Sufficient quantity of flux shall be
selected from each lot (see 4.5.3.1) for use in the preparation of such welds
as may be required in the detail specification.
4.6 Inspection procedures.
4.6.1 Visual and dimensional examination.  Sample lengths and pieces
selected in accordance with 4.5.4.2 shall be examined to verify conformance to
visual and dimensional requirements specified in section 3 herein and in the
detail specification.
4.6.2  Quality conformance tests.  Samples selected in accordance with
4.5.4.4, 4.5.4.5 and 4.5.4.6 shall be used to perform such tests as may be
required in the detail specification to verify conformance to the temper
for the electrode, chemical composition of electrode or rod,
of weld deposit and mechanical properties of welded joints.  Samples
of flux selected in accordance with 4.5.5.2 shall be used for SAW welds.
4.6.3 Certification of tests.  Results or examinations and tests (see 4.6.1
and 4.6.2) shall be certified by a responsible company official and furnished to
the consignee, as required in the detail specification.  Except for controlled
mill coil chemical composition lots (see 4.5.1.1.2), the contractor shall report
the heat number and material source (melter), for lots identified by heat of
metal (see 4.5.1.1.1).  The certification report shall be prepared in accordance
with the data ordering document (see 6.2.2).
4.7 Test procedures.
4.7.1 Preparation of welds.
4.7.1.1 Welding equipment.  Manual, semi-automatic or machine equipment
shall be used with either the GMA or GRA processes for testing electrode or cut-
length rod.  The equipment used for SAW shall be a standard commercial type
with automatic welding head, designed for use with and capable of a uniform and
controlled feed of granular flux and bare wire, a uniform and controlled speed
of travel, and of sufficient power capacity for the welding operations required
in the detail specifications.  Equipment shall be supplied with welding current
from either motor generator or rectifier in accordance with NEMA EW 1.
4.7.1.2 Shielding gas. Shielding gas shall be as specified in the detail
specification.

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business