 |
|||
|
Page Title:
Inspection and test results, process controls |
|
||
| ||||||||||
|
|  MIL-E-63300A(AR)
6.4 Drawings. Drawings listed in Section 2 of this
specification under the heading US Army Armament Research and
Development Command (ARIMDCOM) may also include drawings prepared
by, and identified as, Edgewood Arsenal, Frankford Arsenal, Rock
Island Arsenal, or Picatinny Arsenal drawings. Technical data
originally prepared by these activities is now under cognizance of
A RRADCOM.
6.5 Inspection and test results, process controls. Inspection,
and test results inspections and process controls procedures shall
be sent to: Commander, U.S Army Armament Research and Development
Command Attn: DRDAR-QAA-M, Dover, New Jersey 07801.
6.6 Data requirements. Deliverable data required by this
specification is cited in the following paragraph:
Paragraph
DATA Requirements
Applicable DID
4.5.17
Printed wiring board
DI-T-5372
cleaning procedures
(Tailored)
Integrated circuit
DI-T-5372
4.5.18
handling procedure
(Tailored)
Quality assurance
DI-T-5372
4.5.19
soldering plan
(Tailored)
Quality Inspection Test
3.7, 3.7.1
4.4.2.3
Demonstration and Evaluation
DI-R-1724
4.5.20, 4.5.21
Report
(Tailored)
6.7 Special defect. A defect, other than critical (see
MIL-A-48078) that judgement and experience indicate may, depending
upon the degree of variance from the design requirement:
a. Result in hazardous or unsafe conditions for individuals
using, maintaining or depending upon the product or
b.
Prevent performance of the tactical function of a major
end item.
6.8 Change from previous issue. Due to the extensiveness of
the changes, asterisks to identify changes with respect to the
previous issue are not used in this revision.
Custodian:
Preparing Activity:
Army-AR
Amy-AR
Project No:
1345-A163
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals