 |
|||
|
Page Title:
Finishing Section, Modular Printing System |
|
||
| ||||||||||
|
|  INCH-POUND]
MIL-F-44402(GL)
16 February 1990
MILITARY SPECIFICATION
FINISHING SECTION, MODULAR PRINTING SYSTEM
This specification is approved for use by the Natick Research, Development, and
Engineering Center, Department of the Army, and is available for use by all
Departments and Agencies of the Department of Defense.
1.
SCOPE
1.1 Scope. This specification covers the finishing section of the Modular
Printing System (see 6.1).
APPLICABLE DOCUMENTS
2.
2.1 Government Documents.
2.1.1 Specifications, standards, and handbooks. The following specifi-
cations, standards, and handbooks form a part of this document to the extent
specified herein. Unless otherwise specified, the issues of these documents are
those listed in the issue of the Department of Defense Index of Specifications
and Standards (DODISS) and supplement thereto, cited in the solicitation (see
6.2).
Beneficial comments (recommendations, additions, deletions) and any
pertinent data which may be of use in improving this document should be
addressed to: U.S. Army Natick Research, Development, and Engineering
Center, Natick, MA 01760-5014 by using the self-addressed Standardization
Document Improvement Proposal (DD Form 1426) appearing at the end of this
document or by letter.
t
1
FSC 3610
AMSC N/A
Approved for public release; distribution is unlimited.
DISTRIBUTION STATEMENT A.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals