 |
|||
|
|
|||
| ||||||||||
|
|  MIL-F-60037C (PA)
The flare with ejector set assembly shall be subjected
to the following cycling tests at room temperature in addi-
tion to the frequency scan and resonance endurance tests.
The equipment as mounted for the resonance tests shall be
vibrated at the displacements and accelerations defined by
the attached test curve with the frequency in a cycle con-
tinuously varied between the limits of the applicable curve
of approximately 15 minutes. The rate of change of frequency
shall be proportional to the frequency. The total test time
shall be 1-1/2 hours. This test shall be repeated with
vibration along each of three mutually perpendicular axes.
The cycling test may be broken into convenient ranges, pro-
vided the cycling rates and test times for each range are
not change. Testing shall be performed in accordance with
9200445 and 9200050.
4.5.2.2 Examination. - During and following vibration,
a check shall be made for broken screw, cap. Following the
vibration aircraft test, the squib circuit resistance shall
be checked for informational purposes. All cartridge assem-
blies shall be x-rayed to meet requirements of paragraph
4.4.2.7 of MIL-F-60035 and to determine whether any component
became dislodged or broken. All thirty two flares shall be
fired by delivering 28 volts and 3 amperes to each flare
(see 6.5).
4.5.3 Moisture content (packing material). - The mois-
ture content shall be determined in accordance with Method
240 of Specification UU-P-31 except that a 50 gram sample
shall be used.
PREPARATION FOR DELIVERY
*5.
5.1 Preservation and packaging.
5.1.1 Level A. - The flare set, AN/ALA-17 shall be
preserved and packaged in accordance with dwg 8860600.
5.2 Packing.
5.2.1 Level A. - The carton shall be packed as speci-
fied in dwg 8860555.
*5. 3 Marking. - The marking shall be in accordance with
dwg 8860600 and 8860555.
16
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals