 |
|||
|
|
|||
| ||||||||||
|
|  MIL-F-63281A (AR)
force shall act against the No. 1 gear. Upon removal of the
required force, the maximum permissible gap shall be inspected for
compliance with the drawing requirement. Any No. 1 gear and pinion
assembly that fails the requirement shall be classed defective.
4.5.6.2 Load test of No. 2 gear and pinion assembly. Apply an
axial load perpendicular to the No. 2 gear and in such a direction
as to test the assembly of the No. 2 gear and pinion. The required
force shall act against the No. 2 gear. Upon removal of the
required force, the maximum permissible gap shall be inspected for
compliance with the drawing requirement. Any No. 2 gear and pinion
assembly that fails the requirement shall be classed defective.
4.5.6.3 Load test of escapement gear and pinion assembly.
Apply an axial load perpendicular to the escapement gear and in such
a direction as to test the assembly of the escapement gear and
pinion. The required force shall act against the escapement gear.
Upon removal of the required force, the maximum permissible gap
shall be inspected for compliance with the drawing requirement. Any
escapement gear and pinion assembly that fails the requirement shall
be classed defective.
4.5.6.4 Load test of lever shaft. Apply the axial load
perpendicular to the lever and in such a direction as to test the
assembly of the lever and shaft. The required force shall act
against the lever. Upon removal of the required force, the maximum
permissible gap shall be inspected for compliance with the drawing
requirement. Any lever shaft that fails the requirement shall be
classed defective.
4.5.6.5 Load test of lever pallet. Apply an axial load
perpendicular to the lever and in such a direction as to test the
assembly of the lever and the lever pallet. The required force
shall act against the lever. Upon removal of the required force,
the height of the lever pallet above the lever shall be inspected
for compliance with the drawing requirement. Any lever pallet that
fails the requirement shall be classed defective.
4.5.6.6 Load test of annular gear. Apply a load perpendicular
to the rotor and in such a direction as to test the assembly of the
annular gear studs to the annular gear and the rotor. The required
force shall act against the rotor. Upon removal of the required
force, the distance from the face of the rotor to the outside face
of the annular gear shall be inspected for compliance with the
drawing requirement. Any annular gear that fails the requirement
shall be classed defective.
75
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals