 |
|||
|
|
|||
| ||||||||||
|
|  MIL-G-19027D(OS)
3.4.2.2 High temperature, operating. The steering gyro shall be cap-
able of meeting all the performance requirements of this specification
while undergoing the test specified in 4.4.2.2.
3.4.2.3 Low temperature, nonoperating. The steering gyro shall meet
all the performance requirements and product characteristics of this
specification after being tested as in 4.4.2.3.
3.4.2.4 Low temperature, operating. The steering gyro shall be cap-
able of meeting all the performance requirements of this specification
while undergoing the test specified in 4.4.2.4.
3.5 Cleanup. Prior to and after final assembly, all parts, components,
and the assembly shall be thoroughly cleaned of loose, spattered, or ex-
cess solder, metal chips, and other foreign matter. Burrs and sharp edges,
as well as rosin flash, shall be removed.
3.6 Workmanship. The equipment, including all parts and accessories,
shall be constructed and finished in a manner to ensure compliance with
all requirements of this specification. Particular attention shall be
paid to neatness and thoroughness of soldering, wiring, marking of parts
and assemblies, impregnation of coils, plating, painting, machine screw
assemblage, welding, brazing, and freedom Of parts from all burrs and
sharp edges. The standards of workmanship exhibited in any approved pre-
production sample, subject to any qualification stated in the Government's
notice of approval, shall be determinative of the requirements of the con-
tract relative to workmanship insofar as not specifically covered by ap-
plicable specifications.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the
contract or purchase order, the supplier is responsible for the perform-
ance of all inspection requirements as specified herein. Except as other-
wise specified in the contract or order, the supplier may use his own or
any other facilities suitable for the performance of the inspection re-
quirements specified herein, unless disapproved by the Government. The
Government reserves the right to perform any of the inspections set forth
in the specification where such inspections are deemed necessary to as-
sure supplies and services conform to prescribed requirements.
Inspection of the steering gyro
4.2 Classification of inspections.
shall be classified as follows:
(a) Preproduction inspection (paragraph 4.4)
(b) Quality conformance inspection (paragraph 4.5)
8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals