 |
|||
|
|
|||
| ||||||||||
|
|  MIL-G-85103B(AS)
bursts. A power take-off shall be provided to power and synchronize the ammuni-
tion handling system.
3.7.4.4 Recoil control devices. The recoil control devices shall reduce
the gun recoil and counter-recoil loads to levels specified herein. The recoil
control devices may be integral with the gun mechanism or a separates bolt-on
item. The recoil control devices shall carry all fore and aft loads, including
firing loads.
3.8 Workmanship. Workmanship and finish shall be in accordance with the
highest grade practice used in manufacturing military weapons. Finished items
and parts shall not exhibit poor material and processing such as seams, laps,
laminations, cracks, visible steps, sharp edges, nicks, scratches, burrs, de-
formations, and missing operations which may affect serviceability, functioning,
operation, or safety. Fins and other extraneous metal shall be removed from case
of forged parts. When doubt exists concerning acceptability or the contractor's
workmanship, the questionable physical item shall be submitted to the
responsible technical agency for decision. No welding shall be allowed on gun
high pressure areas. Nonconforming material, salvage operation, and repair
operations shall be in accordance with the established procedures of the
contractor material review board with government approval.
QUALITY ASSURRANCE PROVISIONS.
4.
4.1 Responsibility for inspection. Unless otherwise specified in the
contract or purchase order, the contractor is responsible for the performance of
all inspection requirements as specified herein. Except as otherwise specified
in the contract or purchase order, the contractor may use his own or any other
facilities suitable for the performance of the inspection requirements specified
herein, unless disapproved by the Government. The Government reserves the right
to perform any of the inspections set forth in the specification where such
inspections are deemed necessary to assure supplies and services conform to
prescribed requirements.
4.2 Classification of inspctions. The inspection requirements specified
herein are classified as follows:
a. Quality conformance inspection (see 4.3).
Qualification inspection (see 4.4).
b.
4.3 Quality conformance inspection.
4.3.1 Quality conformance examination and tests. Each gun system shall be
subjected to the examination and tests of Table IV, Group I and II.
22
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals