 |
|||
|
|
|||
| ||||||||||
|
|  MIL-G-85231(AS)
5.1.1 Level A.
5.1.1.1 Cleaning.
Control groups shall be cleaned in accordance with
MIL-P-116.
5.1.1.2 Drying.
Control groups shall be dried in accordance with
MIL-P-116.
5.1.1.3 Unit packs. Unless otherwise specified in the contract, (see
6.2.1), each control group shall be individually unit packed in accordance
with the methods of MIL-P-116 designated herein ensuring compliance with the
applicable requirements of that specification.
5.1.2 Industrial. The industrial preservation of control groups shall be
In accordance with MIL-STD-1188.
5.2 Packing. Packing shall be level A or industrial, as specified in the
contract see. 2 . 1 ) .
6
5.2.1 Level A. The packaged control group shall be packed in fiberboard
containers conforming to PPP-B-636, class weather resistant, style optional,
spectal requirements. In lieu of the closure and waterproofing requirements
in the Appendix of PPP-B-636, closure and waterproofing shall be accomplished
by sealing all seams, corners and manufacturer's joints with tape, two tnches
minimum width, conforming to PPP-T-60, Class 1 or PPP-T-76. Banding
reinforcement requirements) shall be applied in accordance with the Appendix
to PPP-B-636 using nonmetallic or tape banding only. When the gross weight
exceeds 200 pounds or the container length and width is 48 inches x 24 inches
or more and the weight exceeds 100 pounds, 3 x 4 inch skids (laid flat) shall
be applied in accordance with the requirements of the container specification.
5.2.2 Industrial. The preserved control groups shall be packed in
accordance with MIL-STD-1188.
5.2.3 Unitized loads. Unitized loads, commensurate with the level of
packing specified in the contract or purchase order, shall be used whenever
total quantities for shipment to one destination equal 40 cubic feet or more.
Unitized loads shall be uniform in size and quantities to the greatest extent
practicable.
5.2.3.1 Level A. Control groups, packed as specified in 5.2.1, shall be
unitized on pallets accordance with MIL-STD-147, load type I, with a
fiberboard cap (storage aid 4) positioned over the load.
5.3 Marking.
5.3.1 Level A. In addition to any special or other identification
marking specified in the contract (see 6.2.1), each unit pack, intermediate
and exterior container and unitized load shall be marked in accordance with
MIL-STD-129.
5.3.2 Industrial.
Industrial marking shall be in accordance with
MIL-STD-1188.
27
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals