 |
|||
|
|
|||
| ||||||||||
|
|  MIL-G-85299(AS)
4.5.4.2 Scope of tests. Special tests shall consist of such tests as are
acceptable to the procuring activity. Test procedures previously approved for
the first article tests may be used where applicable.
4.5.5 Equipment failure. Should a failure occur during either the sample,
reliability assurance or special tests, the following action shall be taken:
a,
Determine the cause of failure.
Determine if the failure is an isolated case or a repetitive failure.
b.
Where practical, include a test (in the individual test) to check all
c.
test sets for this requirement until assurance is forthcoming that the
defect has been corrected.
The procedures used for conducting
4.6 Methods of examination and test.
first article tests and quality conformance tests are subject to
Government modification or additional testing deemed necessary to determine
compliance with the requirements of this specification and the contract.
When approved test procedures are available from previous contracts, such
procedures will be provided and may be used when their use is authorized by
the procuring activity (subject to modification or additional tests when
deemed necessary.
4.7 Pre-submission tests. No item, part, or complete equipment shall be
delivered by the contractor until it has been previously tested and inspected
by the contractor and found to comply with all-applicable requirements.
5.
PACKAGING
5.1 Guided
Missile Launcher Test Set AN/ASM-464A. The test set shall be
preserved,
packaged, and packed in accordance with the requirements of DL
1058AS11OO
and MIL-P-116, Method II, Level A. The outer container shall be
marked for
shipment in accordance with MIL-STD-129.
5.2 Major components and parts. All major components and all parts, that
are ordered as end items, shall be preserved, packaged, packed and marked for
the level of shipment specified in the contract or purchase order in
accordance with MIL-E-17555. If the component or part is not covered in
MIL-E-17555, the method of preservation for Level A shall be determined in
accordance with the selection chart in Appendix D of MIL-STD-794.
6.
NOTES
6.1 Intended use. The test set specified herein is used to perform
operational checks of the Sidewinder launching circuits and aircraft circuitry
associated with the Guided Missile Launcher, LAU-7A. The test set is used to
simulate the Sidewinder missile during Visual Target Acquisition System (VTAS)
and Sidewinder Expanded Acquisition Mode (SEAM).
26
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals