 |
|||
|
Page Title:
Table III. List of defects for the finished dimensions of the piercing pins |
|
||
| ||||||||||
|
|  MIL-I-23145B
List of defects for the finished dimensions of the piercing pins.
TABLE III.
I
I
Defect
Examine
Any measurement deviating from 3.3.4
Check the various dimensions of the
through 3.3.5 and figures 3 and 7, as
piercing pin as specified in figures 3
applicable, and applicable tolerances
and 7, as applicable, and the "O" ring.
shall be enumerated as dimensional
defect.
TABLE IV.
Classification of defects for the visual examination of the
inflation assemblies.
Major
Any surface rough, misaligned or contains any nick, unspec-
101.
ified sharp edge, crack, burr, pit, dent, sliver, scale,
embedded foreign matter, loose particle or other imperfection.
Any finish missing or any component improperly finished.
102,
Any component missing, malformed, corroded, fractured, chipped,
103.
bent, distorted or damaged.
Any component loose, detached, not assembled as specified or
104.
otherwise not securely retained.
Any end of the grooved taper pin protruding from the body.
105.
Any functional part that works with difficulty.
106.
Any gas passage missing.
107.
Any threads missing, stripped, torn, broken or otherwise
108.
defective.
Any component not as specified or any defect of a component or
109.
.
defect of assembly not herein classified which seriously affects
the serviceability or appearance.
1100
Any component, component part or required operation omitted
or any operation not herein classified improperly performed
thereby seriously affecting serviceabiltiy or appearance.
Minor
Any markings, missing, incorrect, illegible, incomplete, not
201.
of a permanent nature or improperly located.
When applicable, contract number and date of manufacture not
202.
coated (see 3.5).
Surface unclean; or foreign matter appearing on surface.
203.
Any component not as specified or any defect of a component
204.
not herein classified which does not seriously affect the
serviceability or appearance.
Any component, component part or required operation omitted
205.
or any operation not herein classified improperly which does
not affect serviceability or performance.
18
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals