 |
|||
|
|
|||
| ||||||||||
|
| MIL-I-46497B
article sample shall be inspected for all requirements of the drawings and specifications. The Government
reserves the right to require new first article samples until such time as an acceptable sample is submitted (see
6.4).
4.5 Quality conformance inspection.
4.5.1 Lot.
4.5.1.1 Submission of product. Unless otherwise specified by the contracting activity, formation and
identification of lots shall be in accordance with MIL-STD-105.
4.5.1.2 Size of lot. For the purpose of identification and shipment, the shipping lots of metal parts
assemblies shall consist of 1200 assemblies maximum, provided the homogeneity requirement of inspection
lots have been retained.
4.5.2 Examination. One hundred percent examination shall be performed for all critical defects.
Examination for major and minor defects shall be performed in accordance with the classification of defects.
Four power (4x) magnification may be used for inspection of such defects as burr and foreign matter.
Inspection for rubber O-rings shall be in accordance with MIL-STD-413. When compliance with the
applicable requirement is in doubt as a result of visual examination, the characteristic shall be measured or
gaged to determine acceptability. All nonconforming material shall be rejected.
4.5.2.1 Pin, Initiator, Drawing 8595403, covering a detail of Drawing 8595817.
Characteristics
Defect
Method of Inspection
Critical
None defined
Major
101
Concentricity of groove in head with body
Gage
102
Symmetry of head with body
Gage
103
Diameter of body
Gage
104
Diameter of groove in body
Gage
105
Diameter of groove in head, min
Gage
106
Length to shoulder at head, min
Gage
107
Location of groove in head
Gage
108
Location of groove in body
Gage
109
Profile of groove in body
Measure
110
Profile of groove in head
Measure
111
Metal defective
Visual
112
Protective finish inadequate or defective
Visual
113
Surface finish on body and body groove improper
Visual
114
Burr
Visual
115
Foreign matter
Visual
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals