 |
|||
|
|
|||
| ||||||||||
|
|  MIL-L-48407B(Mu)
4.1.1 General provisions. - The component and subassembly inspection
requirements of MIL-F-13926 form a part of the Quality Assurance Provisions
of this specification. Definitions of inspection terms shall be as listed
in MIL-STD-109.
4.2 First article (initial production) approval.- The requirement
for first article approval and the responsibility (Government or contrac-
tor) for first article testing shall be as specified in the contract.
The sample for first article approval tests shall consist of four trainer
assemblies plus four each of all items covered by SQAP. One sample trainer
shall be subjected to the fungus test (4.6.4.2.11), humidity non-operating
(4.6.4.2.8) and salt fog (4.6.4.2.9). The remaining 3 samples shall be
subjected to all other inspections and tests herein. The sample shall
be manufactured In the same manner, using the same materials, equipment,
processes, and procedures as used in regular production. All parts and
materials, including packaging and packing shall be obtained from the
same source of supply as used in regular production.
4.2.1 Government testing.- When the Government is responsible for
conducting first article approval tests, the contractor, prior to sub-
mitting the sample to the Government, shall inspect the sample to insure
that it conforms to all the requirements of the contract and submit a
record of this inspection with the sample, including certificates of
conformance for materials.
4.2.2 Cotnractor testing. - When the contractor is responsible for
conducting first article approval tests, the sample shall be inspected
by the contractor for all the requirements of the contract. The sample
and a record of this inspection, including certificates of conformance
for materials, shall be submitted to the Government for approval. The
Government reserves the right to witness the contractor's inspection.
4.3 Inspection provisions.
4.3.1 Submission of product.- Unless otherwise specified by the
contracting officer, inspection lot size, lot formation and presentation
of lots shall be accordance with "Submission of Product" provisions
of MIL-STD-105.
4.3.2 Examination and tests.
4.3.2.1 Components and subassemblies.- All components and sub-
assemblies shall be inspected in accordance with the inspection provisions
contained in Supplementary Quality Assurance Provision (SQAP) listed in
the technical data package (TDP). In the absence of SQAP's the applicable
Quality Assurance Provisions of MIL-F-13926 shall apply.
4.3.2.1.1 Certification.- Prior to assembly, the laser plasma tube,
high voltage power supply, and the timing module shall be certified to
the requirements and tests in their respective specifications. Certifi-
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals