Packaging, packing, and marking

Page Title: Packaging, packing, and marking
Back | Up | Next

Web
www.tpub.com

Information Categories

....

MIL-L-60244A(MU)

horizontal and vertical reticle lines) of the reflected image, as measured

on the viewing collimator. Any vertical displacement of the boresight

point of the reflected image is the amount of backlash. Backlash shall

not exceed the limit specified in 3.7.2.

NOTE 3: During this operation (4.6.4.1), if overtravel occurs the test

shall be nullified and the procedure specified for backlash shall

again be performed.

4.6.4 Operability. - Special testing equipment conforming to the

requirements of 4.5,2.3.2 shall be utilized for this test. Position and

condition the linkage assembly as specified in 3.7a through 3.7e, and

attach the testing equipment to measure direct force, push or pull to the

spherical bearing on the free end of the linkage. Direct force shall be

measured while actuating the connector, by means of the direct force tester,

in the appropriate direction until Surface "X" of Coupling 8620152 is

rotated through its travel range specified in 3.7.1. The direct force

applied at the connector to rotate the coupling shall conform to the

applicable requirement of 3.7.1 at the temperature specified in 3.4.

4.6.6 Workmanship. - The linkage assembly shall meet the require-

ments specified in 3.3 when subjected to a visual and tactile examination.

5. PREPARATION FOR DELIVERY

5.1 Packaging, packing, and marking. - Packaging, packing, and

marking shall be in accordance with Packaging Data Sheet 8287301. The

level of protection shall be as specified in the procurement document.

NOTES

6.1 Intended use. - The linkage assembly is a component of the

gunner's fire control system in the Armored Reconnaissance Airborne

Assault Vehicle XM551. This assembly serves as a link between the per-

iscope input coupling and the weapon and provides for elevation of the

line of sight coaxially with the weapon.

6.2 Ordering data.- Procurement documents should specify:

(a) Title, number, and date of this specification.

(b) Selection of applicable levels of preservation, packaging

and packing.

(d) Provisions for first article testing (see 4.2).

Preparing activity:

Custodian:

Army - MU

Project No. 1240-A217

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business