 |
|||
|
Page Title:
Other Government documents. drawings and publications |
|
||
| ||||||||||
|
|  (Unless otherwise indicated, copies of federal and military specifications,
standards, and handbooks are available from the Standardization Documents Order
Desk, Bldg 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.)
2.1.2 Other Government documents. drawings and publications. The following
other Government documents, drawings, and publications form a part of this
document to the extent specified herein. Unless otherwise specified, the issues
are thOse cited in the solicitation.
DRAWINGS
NAVAL AIR SYSTEMS COMMAND (CAGE Code 30003)
DL1335AS380
Launcher, Rocket LMU-23A/E
DL1335AS850
Launcher, Rocket LMU-23B/E
1335AS260
Igniter, PVU-3B/E
1335AS275
Igniter, PVU-3A/E
(Application for copies should be addressed to Commanding Officer, Naval Air
Technical Services Facility (NATSF) (Code 3121), 700 Robbins Avenue,
Philadelphia, PA 19111.)
2.2 Non-Government Duplications. The following documents form a part of
this document to the extent specified herein. Unless otherwise specified, the
issues of the documents which are DOD adopted are those listed in the issue of
the DODISS cited in the solicitation. Unless otherwise specified, the issues of
documents not listed in the DODISS are the issues of the documents cited in the
solicitation (see 6.2).
q
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI B46.1
Surface Texture (Surface Roughness Waviness
and Lay)
(Application for copies should be addressed to the American National
Standards Institute, 1430 Broadway, New York, NY 10018.)
(Non-Government standards and other publications are normally available from
the organizations that prepare or distribute the documents. These documents also
may be available in or through libraries or other informational services.)
2.3 Orde r of precedence
In the event of a conflict between the text of
this document and the references cited herein, the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and
regulations unless a specific exemption has been obtained.
REQUIREMENTS
3.
3.1 First article. When specified (see 6.2), a sample shall be subjected to
first article inspection (see 6.4) in accordance with 4.4.
3.2 Mat erial and process
The material and processes utilized in the
fabrication of the launcher shall conform to the requirements indicated on the
drawings and specifications listed on DL1335AS380 and DL1335AS850 (see 4.1.3,
6.2, and 6.3).
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals