AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
ASTM B 117
Method of Salt Spray (Fog) Testing (DoD adopted)
ASTM D 740
Methyl Ethyl Ketone
ASTM D 877
Dielectric Breakdown Voltage of Insulating Liquids Using Disk
Electrodes (DoD adopted)
ASTM D 942
Oxidation Stability of Lubricating Greases by the Oxygen Bomb
Method (DoD adopted)
ASTM D 1310 Flash Point of Liquids by Tag OpenCup Apparatus (DoD adopted)
ASTM D 2266 Wear Preventive Characteristics of Lubricating Grease (FourBall
Method) (DoD adopted)
(Applications for copies should be addressed to American Society for Testing and
Materials, 1916 Race Street, Philadephia, PA 191031137.)
DEPARTMENT OF TRANSPORTATION
29 CFR 1910.2100 Material Safety Data Sheet, Preparation and Submission of
49 CFR 173.300 Department of Transportation Hazardous Materials Regulation
(Application for copies should be addressed to Department of Transportation, 400 7th
Street, SW, Washington, DC 20590.)
(NonGovernment standards and other publications are normally available from the
organizations that prepare or distribute the documents. These documents also may be
available in or through libraries or other informational services.)
2.3 Order of precedence. In the event of a conflict between the text of this document
and the references cited herein, the text of this document takes precedence. Nothing in
this document, however, supersedes applicable laws and regulations unless a specified
exemption has been obtained.
3.1 First article. When specified (see 220.127.116.11), a sample shall be subjected to first article
inspection in accordance with 4.4.
3.2 Material safety data sheet. Material safety data sheets shall be prepared in
accordance with FEDSTD313 and 29 CFR 1910.2100. When FEDSTD313 is at
variance with the CPR, 29 CFR 1910.2100 shall take precedence, modify and
3.3 Properties. The compound shall conform to the properties specified in table I.
3.3.1 Type I compound. The type I compound (See table I) shall be contained in a gas
pressurized container with a 80 percent volume of the compound and 2.7 percent
volume of carbon dioxide.
3.3.2 Type II compound. The type II compound (see table I) shall be in bulk form.
3.3.3 Type packaging