may be used in
inspection, and shall be In,
q ccordance with Table I.
TABLE I - SAMPLING PlAN
s ample Size
Use 100% Inspection
26 - 3 5
36 - 5 0
51 - 150
151 - 3 0 0
301 - Over
4.4.2 Disposition of non-conforming product.- Acceptance
and rejection numbers are expressed in terms of d efective units.
One or more defects on any unit shall constitute q defective unit.
Disposition of non-conforming components shall be in accordance
with Standard MIL-STD-105.
Control for requirements of material shall
equ ipment.- Supply, calibration, maintenance
and use of inspection equipment shall be in accordance with Specifi-
4.6.1 Accuracy requirements 0 - Inspection equipment which in-
corporates features for measuring values or sizes established by
product requirements shall be capable of measUring
within an accuracy of ten percent of the specification
otherwise specified. In cases where the ten percent q ccuracy
Imposes impractical or very difficult design and fabrication problems,
or results in q test equipment cost factor which is exorbitant in
relation to the cost and application of the product to be Inspected,
the Government shall be expeditiously advised i n order that necessary
appropriate action can be taken.
The classification of defects
constitute the minimum inspection require-
in Tables II an
ments to be performed prior to acceptance or rejection by lots.
The Government reserves the right to inspect for any or all
requirements and to reject individual non-conforming items.