D. Bolt circle diameter and bolt spacing in flange for extender.
E. Bolt circle diameter and bolt spacing in flange for clock
F. Inside diameter of coil tube.
G. Inside length and straightness of coil tube.
EL Location and spacing of holes in suspension lug pads for the 30
inch center-to-center spaced lugs.
L Location and spacing of holes in suspension lug pads for the
14 inch center-to-center spaced lugs.
J. Profile and location of holes in suspension lugs prior to
asse mbly on the case.
K Inside diameter and depth of battery compartment.
L. Inside diameter of coil tube coupling.
M. Bolt circle diameter and bolt spacing in flange for coil "tube.
No Bolt circle diameter and bolt spacing in flange for filling hole.
o. Bolt circle diameter and bolt spacing in flange for tail cover.
P. Inside diameter of flange for tail cover.
Q. Inside diameter of extender well.
R. Location of center of extender well with relation to center of
extender well flange.
4,1.2 Sampling. - Unless otherwise specified, and when applicable,
the sampling plans and procedures used by Government inspector in the
determination of the acceptability of products submitted by a supplier for
Government inspection shall be in accordance with the provisions set
forth in MIL-STD-105.
4. 1.3 Pre-production sample. - Unless otherwise specified for each
contract or order, a representative sample of (10) Mine Cases Mark 25
Mod 1 shall be manufactured using the methods and procedures proposed
for the production lot. These cases shall be submitted to the Government
inspector for pre -production tests at an activity designated in the contract
or by the Bureau of Ordnance, for purposes of determining compliance
with the requirements of the contract, specifications and drawings.
Further production of the item by the contractor prior to approval of the
contracting activity or the completion of tests on pre -production samples
shall be at the contractor's risk, Pre-production samples accepted will be
applied as part of the quantity specified by the contract or order.