11 August 2005
15 October 2003
MICROCIRCUITS, LINEAR, SAMPLE AND HOLD CIRCUITS, MONOLITHIC SILICON
Reactivated for new design as of 15 October 2003. May be used for either new or existing design acquisition.
This specification is approved for use by all Departments and Agencies of the Department of Defense.
The requirements for acquiring the product herein shall consist of this specification sheet and MIL-PRF-38535.
1.1 Scope. This specification covers the detail requirements for monolithic silicon, sample and hold circuits. Two
product assurance classes and a choice of case outlines and lead finishes are provided and are reflected in the
complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-
38535, (see 6.4)
1.2 Part or identifying Number (PIN). The PIN is in accordance with MIL-PRF-38535, and as specified herein.
1.2.1 Device types. The device types are as follows:
Sample and hold circuits, 10 kΩ load
Sample and hold circuits, 2 kΩ load
1.2.2 Device class. The device class is the product assurance level as defined in MIL-PRF-38535.
1.2.3 Case outline. The case outline is as designated in MIL-STD-1835 and as follows:
GDIP1-T8 or CDIP2-T8
Comments, suggestions, or questions on this document should be addressed to: Commander, Defense
Supply Center Columbus, ATTN: DSCC-VAS, 3990 East Broad St., Columbus, OH 43218-3990, or emailed
to firstname.lastname@example.org. Since contact information can change, you may want to verify the currency of this
address information using the ASSIST Online database at http://assist.daps.dla.mil.