17 January 2006
15 January 1988
MICROCIRCUITS, DIGITAL, HIGH-SPEED CMOS,
FLIP-FLOPS, MONOLITHIC SILICON, POSITIVE LOGIC
Reactivated after 17 Jan. 2006 and may be used for new and existing designs and acquisitions.
This specification is approved for use by all Departments
and Agencies of the Department of Defense.
The requirements for acquiring the product herein shall consist of this specification sheet and MIL-PRF 38535.
1.1 Scope. This specification covers the detail requirements for monolithic silicon, high speed CMOS, logic
microcircuits. Two product assurance classes and a choice of case outlines and lead finishes are provided and are
reflected in the complete part or identifying number (PIN). For this product, the requirements of MIL-M-38510 have
been superseded by MIL-PRF-38535 (see 6.3).
1.2 Part or identifying number (PIN). The PIN is in accordance with MIL-PRF-38535 and as specified herein.
1.2.1 Device types. The device types are as follows:
Dual JK flip-flop with clear
Dual D positive-edge triggered flip-flop with clear and preset
Dual JK negative-edge triggered flip-flop with clear
Dual JK positive-edge triggered flip-flop with clear and preset
Dual JK negative-edge triggered flip-flop with clear and preset
Quad D-type flip-flop with 3-state outputs and clear
Hex D-type flip-flop with clear
Quad D-type flip-flop with clear
Dual D-type positive-edge triggered flip-flop with clear and preset,
TTL compatible inputs
1.2.2 Device class. The device class is the product assurance level as defined in MIL-PRF-38535.
1.2.3 Case outlines. The case outlines are as designated in MIL-STD-1835 and as follows:
GDIP1-T14 or CDIP2-T14
GDFP1-F14 or CDFP2-F14
GDIP1-T16 or CDIP2-T16
GDFP2-F16 or CDFP3-F16
Square leadless chip carrier
Comments, suggestions, or questions on this document should be addressed to: Commander, Defense
Supply Center Columbus, ATTN: DSCC-VAC, P.O. Box 3990, Columbus, OH 43218-3990, or email
CMOS@dscc.dla.mil. Since contact information can change, you may want to verify the currency of this
address information using the ASSIST Online database at http://assist.daps.dla.mil/.