 |
|||
|
Page Title:
Microcircuits, Digital, Advanced CMOS, Flip-Flops, Monolithic Silicon, Positive Logic |
|
||
| ||||||||||
|
|  INCH-POUND
MIL-M-38510/753B
26 November 2003__
SUPERSEDING
MIL-M-38510/753A
27 May 1994
MILITARY SPECIFICATION
MICROCIRCUITS, DIGITAL, ADVANCED CMOS,
FLIP-FLOPS, MONOLITHIC SILICON, POSITIVE LOGIC
Reactivated after 26 Nov. 2003 and may be used for either new or existing design acquisitions.
This specification is approved for use by all Departments
and Agencies of the Department of Defense.
The requirements for acquiring the product herein shall consist of this specification sheet and MIL-PRF 38535
1. SCOPE
1.1 Scope. This specification covers the detail requirements for monolithic silicon, advanced CMOS, logic microcircuits.
Two product assurance classes and a choice of case outlines, lead finishes, and radiation hardness assurance (RHA) are
provided and are reflected in the complete Part or Identifying Number (PIN). For this product, the requirements of MIL-M-38510
have been superseded by MIL-PRF-38535 (see 6.3).
1.2 Part or identifying number (PIN). The PIN should be in accordance with MIL-PRF-38535 and as specified herein.
1.2.1 Device types. The device types should be as follows:
Circuit
Device type
1/
01
02
Dual D-type positive-edge triggered flip-flops with clear and set
1/
03
04
Dual JK positive-edge triggered flip-flops with clear and set
05
Dual JK negative-edge triggered flip-flops with clear and set
1/
06
07
Hex D-type flip-flops with master reset
08
Quad D-type flip-flops with reset
1.2.2 Device class. The device class should be the product assurance level as defined in MIL-PRF-38535.
1.2.3 Case outlines. The case outlines should be as designated in MIL-STD-1835 and as follows:
Descriptive designator
Terminals
Package style
Outline letter
C
GDIP1-T14 or CDIP2-T14
14
Dual-in-line
D
GDFP1-F14 or CDFP2-F14
14
Flat pack
E
GDIP1-T16 or CDIP2-T16
16
Dual-in-line
F
GDFP2-F16 or CDFP3-F16
16
Flat pack
Y
GDFP1-G14
14
Flat pack with gull wing
Z
GDFP1-G16
16
Flat pack with gull wing
2
CQCC1-N20
20
Square leadless-chip-carrier
1/ Device types 01, 03, and 06 were intended to be added in the future, see 6.7.
Comments, suggestions, or questions on this document should be addressed to: Commander, Defense
Supply Center Columbus, ATTN: DSCC-VAC, 3990 East Broad St., Columbus, OH 43216-5000, or email to
cmos@dscc.dla.mil. Since contact information can change, you may want to verify the currency of this
address information using the ASSIST Online database at www.dodssp.daps.mil.
AMSC N/A
FSC 5962
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals