4.4.3 Failure of sample.- Should any one item of a special sampling
fail to meet the specified test requirements, acceptance of the product
shall be suspended by the Government until necessary corrections have been
made by the contractor and resubmitted samples have been approved (see
4.5 Inspection equipment.- Except as otherwise provided for by the
contract, the contractor shall supply and maintain inspection equipment
in accordance with the applicable requirements of MIL-I-45607.
4.5.1 Government furnished inspection equipment.- Where the contract
provides for Government furnished test equipment, supply and maintenance
of test equipment shall be in accordance with the applicable requirements
specified in MIL-I-45607.
4.5.2 Contractor furnished inspection equipment.
126.96.36.199 Government design.- Unless otherwise specified in the con-
tract, all inspection equipment specified by drawing number in specifi-
cations or SQAP forming-a part of the contract shall be supplied by the
contractor in accordance with technical data listed in the technical data
188.8.131.52 Contractor design.- The contractor shall design and supply
inspection equipment compatible with the "Test Methods and Procedures"
specified in 4.6 of this specification and with the component inspection
procedures specified in "Examination" and "Test Facilities" requirements
of MIL-F-13926. Since tolerance of test equipment is normally considered
to be within 10% of the product tolerance for which it is intended, this
inherent error in the test equipment design must be considered as part
of the prescribed product tolerance limit. Thus, concept, construction,
materials, dimensions and tolerances used in the design of test equipment
shall be so selected and controlled as to insure that the test equipment
will reliably indicate acceptability of a product which does not exceed