 |
|||
|
|
|||
| ||||||||||
|
|  MIL-M-46309B(MU)
other facilities suitable for the performance of the inspection require-
ments specified herein, unless disapproved by the Government. The Govern-
ment reserves the right to perform any of the inspections set forth in
the specification where such inspections are deemed necessary to assure
supplies and services conform to prescribed requirements.
4.1.1 General provisions.- The component and subassembly inspection
requirements of MIL-F-13926 form a part of the Quality Assurance Provisions
of this specification. Definitions of inspection terms shall be as listed
in MIL-STD-109.
4.2 First article (initial production) approval.- The requirement
for first article approval and the responsibility (Government or contractor)
for first article testing shall be as specified in the contract. The sample
for first article approval tests shall consist of three (3) mounts and
three (3) each of every component and subassembly covered by SQAP. The
sample shall be manufactured in the same manner, using the same materials,
equipment, processes, and procedures used in regular production. All
parts and materials, including packaging and packing, shall be obtained
from the same source of supply as used in regular production.
4.2.1 Government testing.- When the Government is responsible for
conducting first article approval tests, the contractor, prior to sub-
mitting the sample to the Government, shall inspect the sample to insure
that" it conforms to all the requirements of the contract and submit a record
of this inspection with the sample, including certificates of conformance
for materials.
4.2.2 Contractor testing.- When the contractor is responsible for
conducting first article approval tests, the sample shall be inspected
by the contractor for all the requirements of the contract. The sample
and a record of this inspection, including certificates of conformance
for materials, shall be submitted to the Government for approval. The
Government reserves the right to witness the contractor's inspection.
4.3 Inspection provisions.
4.3.1 Submission of product.- Unless otherwise specified by the
contracting officer, inspection lot size, lot formation and presentation
of lots shall be in accordance with "Submission of Product" provisions
of MIL-STD-105.
4.3.2 Examination and tests.- Components and subassemblies shall be
inspected in accordance with the inspection provisions contained in
MIL-F-13926, and the Supplementary Quality Assurance Provisions (SQAP)
listed in the List of Inspection Documents (IEL) when provided with the
technical data package (TDP). Examinations and tests related to Section
3 herein shall be performed on a single defect (individual characteristic)
basis in accordance with MIL-STD-105, and the sampling plans specified in
Tables I and II. Examinations and tests for Packaging, Packing and Marking
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals