Contractor furnished inspection equipment.

Page Title: Contractor furnished inspection equipment.
Back | Up | Next

Web
www.tpub.com

Information Categories

....

MIL-M-50747(MU)

8 August 1973

4.5 Inspection equipment. Except as otherwise provided for by

the contract, the contractor shall supply and maintain inspection equipment

in accordance with the applicable requirements of MIL-I-45607. The

inspection equipment listed in table V shall be utilized in performing the

tests specified herein.

4.5.1 Government furnished inspection equipment. Where the

contract provides for Government furnished inspection equipment, supply

and maintenance of inspection equipment shall be in accordance with. the

applicable requirements of MIL-I-45607.

4.5.2 Contractor furnished inspection equipment.

4.5.2.1 Government design. Unless otherwise specified in the

contract, all inspection equipment specified by drawing number in speci-

fications or SQAPs forming a part of the contract shall be supplied by the

contractor in accordance with applicable technical data listed in the TDP.

4.5.2.2 Contractor design. The contractor shall design and supply

inspection equipment compatible with the test methods and procedures

specified in 4.6 of this specification and with the component inspection pro-

cedures specified in examination and test facilities provisions of MIL-F-

13926. Since tolerance of inspection equipment is normally considered

to be within 10 percent of the product tolerance for which intended,

this inherent error in the inspection equipment design must be considered

as part of the prescribed product tolerance limit. Thus, concept, con-

struction, materials, dimensions, and tolerances used in the design of

inspection equipment shall be so selected and controlled as to insure that

the inspection equipment will reliably indicate acceptability of a product

which does not exceed 90 percent of the prescribed tolerance limit and per-

mit positive rejection when non-conforming. Construction shall be such

as to facilitate routine calibration of inspection equipment.

4.6

Test methods and procedures.

4. 6.1 Test conditions. Unless otherwise specified, the test

conditions shall be in accordance with the test facilities provisions of

MIL-F-13926.

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business